NerdKits - electronics education for a digital generation

You are not logged in. [log in]

NEW: Learning electronics? Ask your questions on the new Electronics Questions & Answers site hosted by CircuitLab.

Support Forum » MCU Programming Error

September 19, 2010
by ermias
ermias's Avatar

Hi everyone,

I just bought a new MUC from Nerdkits store and tried to load a program on it; however i Keep getting the following error:

    Connecting to programmer: .
    Found programmer: Id = "S ""; type =  
    Software Version = •. ; Hardware Version = ².
    avrdude: error: buffered memory access not supported. Maybe it isn't
    a butterfly/AVR109 but a AVR910 device?
    make: *** [ledarray-upload] Error 1

Can anybody please help me?? Thanks, Ermias

September 19, 2010
by ermias
ermias's Avatar

Hi everyone,

I just figure it out.

Thanks, Ermias

September 20, 2010
by Ralphxyz
Ralphxyz's Avatar

Ermias, besides what Rick said in/on your other post you should also post your solution.

Since you are the latest (of many) who have experienced this problem you can help someone new, who also might see this butterfly prompt.

Ralph

September 20, 2010
by ermias
ermias's Avatar

Hi Ralph and Rick,

Thank you for your advises. I didn't connect the black wire from serial to the ground when I was trying to load my program to the new MUC. That causes the error.

Thanks,

Ermias

Post a Reply

Please log in to post a reply.

Did you know that essentially all power supplies' voltages drop when current is drawn from them? Learn more...