NerdKits - electronics education for a digital generation

You are not logged in. [log in]

NEW: Learning electronics? Ask your questions on the new Electronics Questions & Answers site hosted by CircuitLab.

Everything Else » added a Wattmeter to my mill

March 28, 2017
by Ralphxyz
Ralphxyz's Avatar

I was going to use a ACS712 Current Sensing IC but ended up just ordering a Wattmeter off ebay, it was sooooo much easier!!

I tested at my desk

Then installed on my Clausing 8520 Vertical Mill

1

2

3

Ralph

Post a Reply

Please log in to post a reply.

Did you know that using an alternating excitation voltage can reduce the noise in many sensor measurements? Learn more...