NerdKits - programming the microcontroller (Everything Else)

You are not logged in. [log in]

NEW: Learning electronics? Ask your questions on the new Electronics Questions & Answers site hosted by CircuitLab.

Everything Else » programming the microcontroller

NerdKits » Forums » Everything Else » programming the microcontroller (2 posts)

June 01, 2012 by chaosatom	Hi, For Programming the micro-controller, should pin 14 be connected to gnd or left floating through the SPDT? It didn't say as I was going through the nerdkit tutorial.
June 01, 2012 by pcbolt	Hi chaosatom - For programming, pin 14 should be connected directly to ground.

June 01, 2012
by chaosatom
chaosatom's Avatar

Hi,

For Programming the micro-controller, should pin 14 be connected to gnd or left floating through the SPDT? It didn't say as I was going through the nerdkit tutorial.

June 01, 2012
by pcbolt

Hi chaosatom -

For programming, pin 14 should be connected directly to ground.

Post a Reply

Please log in to post a reply.