NerdKits - Error 1 solution (Support Forum)

You are not logged in. [log in]

NEW: Learning electronics? Ask your questions on the new Electronics Questions & Answers site hosted by CircuitLab.

Support Forum » Error 1 solution

NerdKits » Forums » Support Forum » Error 1 solution (1 post)

September 20, 2011 by Gianni	You have to replace "/dev/ttyUSB0" with "COMX" ,where X is the correct port. I was only replacing the "USB0" with "COM2" so it looked like "/dev/ttyCOM2" Just posting this here in case someone comes across the same problem.

September 20, 2011
by Gianni
Gianni's Avatar

You have to replace "/dev/ttyUSB0" with "COMX" ,where X is the correct port. I was only replacing the "USB0" with "COM2" so it looked like "/dev/ttyCOM2"

Just posting this here in case someone comes across the same problem.

Post a Reply

Please log in to post a reply.