NerdKits - electronics education for a digital generation

You are not logged in. [log in]

NEW: Learning electronics? Ask your questions on the new Electronics Questions & Answers site hosted by CircuitLab.

Basic Electronics » error 1

May 01, 2011
by 6776nft6mfa632dt7rgw
6776nft6mfa632dt7rgw's Avatar

Hi, I,m sending snip and hope you can help me solve my problem with the makefile. thanks for your help Paul Miottke http://i.imgur.com/E9GIz.jpg

May 02, 2011
by hevans
(NerdKits Staff)

hevans's Avatar

Hi,

This is probably the broadest error you can get, so there are quite a few things that could be causing your issue. It basically means that something went wrong in the communication between your PC and the chip. Most of the time this error points to a loose or misplaced wire, or a dead or dying battery. If you include a good close up picture of your setup we might be able to help you spot the problem.

Humberto

Post a Reply

Please log in to post a reply.

Did you know that reading a double floating point variable with scanf requires "%lf" for "long float"? Learn more...