NerdKits - electronics education for a digital generation

You are not logged in. [log in]

NEW: Learning electronics? Ask your questions on the new Electronics Questions & Answers site hosted by CircuitLab.

Support Forum » chip

NerdKits » Forums » Support Forum » chip (5 posts)
November 20, 2010
by igondjo32
igondjo32's Avatar

how do you erease program on the meg168

November 20, 2010
by Ralphxyz
Ralphxyz's Avatar

Hi Sergio, you do not need to worry about erasing a program just load a new program.

The new program will overwrite the old program.

Ralph

November 21, 2010
by igondjo32
igondjo32's Avatar

thanks ralphxyz

December 02, 2010
by igondjo32
igondjo32's Avatar

hi everybody i am having a complication with my nerdkit 1- when i compile the instruction it goes well 2- when i try to program the instruction into the mcu

here the message i get

"make.exe" program make.eexe***no rule to make 'program'. stop. Process Exit code : 2 Time Taken:00:00 is any one can help me understand it and continue with my programing

December 02, 2010
by hevans
(NerdKits Staff)

hevans's Avatar

Hi igondjo32,

I just answered an exact copy of this post this other thread. Please try and only post any question you have once on the forum. There are lots of very helpful people here and I promise you posting the same question twice will not help you get an answer any faster, it will only make the posts more cluttered and less relevant.

Humberto

Post a Reply

Please log in to post a reply.

Did you know that there are Power MOSFETs for switching big loads on and off? Learn more...